Installation Guide

Installation Instructions
Toyota Corolla
Part Numbers:
24814
60200
77186
Hitch Shown In Proper Position
Wiring Access Location: PC3, 4
Equipment Required:
Wrenches: 17mm, 19mm
Existing weldnuts
2
1
If present, remove the tie down brackets from vehicle frame rail. Return bolts and tie down bracket to owner.
1. Raise hitch into position and install fasteners as shown above.
2. Tighten all fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Tighten all M12 CL8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Rev. A4-8-0824814NSheet 1 of 3
z 2008 Cequent Towing Products
Conical washerQty. (4)
2
Hex Bolt, M12 X 1.25 X 35 CL8.8Qty. (4)
1
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
Drawbar must be used in
the RISE
position only.
Drawbar Kit:
3593
Fastener Kit: 24814F
2000 LB (908 Kg) Max Gross Trailer
Weight
200 LB (90.8 Kg) Max Tongue Weight
Frame rails
Note: Fasteners typical
both sides
2009 Fascia
2003-08 Fascia
Form F206 Rev A 5605

Summary of content (3 pages)