Installation Guide

Installation Instructions
Dodge Caliber
Except R/T & SRT4
Part Numbers:
60832
24769
77145
Do Not Exceed Lower of Towing Vehicle
Drawbar Kit:
24732 U-Haul
Hitch Shown In Proper Position
Wiring Access Location: PC1, PC2
Equipment Required:
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Do
Not
Exceed
Lower
of
Towing
Vehicle
Manufacturer’s Rating or
Drawbar must be used in the
Rise
position only.
3591
F t Kit
24769F
Wrenches: 15/16
F
as
t
ener
Kit
:
24769F
2
3
Frame rail
1
Fasteners typical both sides
Bushing
1. Place 5/8 bolts into bushing from the outboard side of the frame rails. Leave flush with the inboard frame rail.
2. Raise hitch into position and push 5/8 bolts through brackets to support hitch.
1
Qty. (4) Hex Bolt 5/8-11 X 4
3
Qty. (4) Hex Nut 5/8-11
2
Qty. (4) Lock Washer 5/8
3. Attached remaining fasteners as shown.
z 2006, 2010 Cequent Performance Products
Sheet 1 of 3 24769N 8-26-10 Rev. D
Tighten all 5/8-11 fasteners with torque wrench to 100 Lb.-Ft. (136 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Form F206 Rev A 5605