Installation Manual

z 2006,2007,2008,2009,2010,2011,2012,2013, 2014 Cequent Performance Products, Inc.
Made in China
30035IN 10/20/2014 Rev. T
TOYOTA TUNDRA 2000 to 2006 (STANDARD CAB LONG BOX ONLY)
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
NOTE: For Toyota Tundra application, part #58197 spacer kit is required. Stack (1) 3/16” and (1) 5/16” thick
slotted spacer to avoid crushing of truck bed.
32-1/2” Long Box (Only)
Side Bracket
Axle Center
Front
of
Vehicle
Rear Edge of
Truck Bed
1/4 1.5-3
1/4 2
*
1/4 2
1/4 2
*
* Optional weld
pattern
Drivers side shown
Measure from Rear Edge of truck
bed to rear edge of base rail.
Long bracket
Short bracket
ROW 1
ROW 2
ROW 3
ROW 4
King Pin Centered approx. 1-1/4”
forward of Axle Center
SHEET 16 0F 19
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
Front
of
Vehicle