Installation Manual

z 2006,2007,2008,2009,2010,2011,2012,2013, 2014 Cequent Performance Products, Inc.
Made in China
30035IN 10/20/2014 Rev. T
DODGE ’94 to 2004 DAKOTA
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Find parallel rows of bed sill spot welds in bed of truck. No drilling should be done in the ~4” between parallel
rows of spot welds where the bed sill sits.
2. Cut 1” from top flange of brackets. Under bed, mount brackets with flanges facing out.
3. Put rear brackets on Row 3 for ‘97 to Present models. Put brackets on Row 4 for ‘96 and Earlier models.
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
Side Bracket
1/4 1.5-3
1/4 2
*
1/4 2
1/4 2
*
*
Optional weld
pattern
Drivers side Dakota Shown
Up to & Including 1996
1997 to 2004
Long bracket
Short brackets
King Pin Centered over Axle
Axle Center
Bed Sill
SHEET 15 0F 19
26” Long Box
and Short Box
Front
of
Vehicle
Rear Edge of
Truck Bed
Measure from Rear
Edge of truck bed to
rear edge of base rail.
Frame Bracket
1"
Cut Off
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.
ROW 1
ROW 2
ROW 3
ROW 4
Front
of
Vehicle