Installation Manual

z 2006,2007,2008,2009,2010,2011,2012,2013, 2014 Cequent Performance Products, Inc.
Made in China
30035IN 10/20/2014 Rev. T
Ford ‘97 to ’03 F-150 & F-250 8500 GVW AND UNDER and ’04 Heritage Series Body Style
IMPORTANT NOTES FOR THIS INSTALLATION:
1. Long and Short Brackets on Driver’s Side may need to be switched to avoid interference with exhaust hanger.
2. May need to move base rail location +/- 1/2” to ensure frame brackets do not interfere with bed sills.
CAUTION!
Read pages 2-3 of these instructions before starting installation. Failure to do so could result in significant vehicle damage!
CAUTION!
Check for obstructions before drilling. Failure to do so could result in damaged fuel or brake lines, structural members, etc.
CEQUENT PERFORMANCE PRODUCTS, INC. does its best to communicate tow vehicle manufacturer changes; however, it is
ultimately the responsibility of the installer to prevent damage due to installation.
29-1/4” Long Box
and Short Box
Side Bracket
Axle Center
Front
of
Vehicle
Rear Edge of
Truck Bed
*
Optional weld
pattern
Drivers side of F150 shown
1/4 1.5-3
1/4 2
*
1/4 2
1/4 2
*
May need to move slightly to
avoid interference with fuel lines
Measure from Rear Edge
of truck bed to rear edge
of base rail.
Long bracket
Short bracket
ROW 1
ROW 2
ROW 3
ROW 4
King Pin Center approx.. 1-1/2”
forward of axle center.
Bed Sill
Front of
Vehicle
SHEET 9 0F 19
NOTE:
Must install center bolt in
one of the center holes in
each rail.
Check to make sure center
bolt does not interfere with
bed sill.