Instructions

32
d) Headless mode function
• The function of this mode is the setting of the forward direction of your race copter with a cardinal point. Preferably
this function must be activated before take-off so that the forward direction is set correctly.
• Place the race copter on the ground in forward direction. Press down the left throttle/rudder control stick to activate
the headless mode. You will hear one beep sound.
• Donotdeactivatetheheadlessmodewhileyouytheracecopter.
• To quit from headless mode, press down the left throttle/rudder control stick again. You will hear one beep sound.
e) Flip function
• Inordertoperformaipduringighttheracecopterhastobeatleast2maboveground.
• Ensure that the race copter is in a stable and nearly horizontal position. Press down the right elevator/aileron control
stick (5). Beeps will sound.
• Selectthedirectionandpresstheelevator/aileroncontrolstickagaintoperforma360ºip.
11. Replacing damaged rotor blades
If one of the blades is damaged following an impact, you must replace it by removing the damaged blade and replacing
itwithanewbladeofthesametype,otherwiseyourracecopterwillnotbeabletoyproperly.Therotorbladesare
available as spare parts and need to be ordered separately.
To replace rotor blades on your race copter please follow the following instructions:
• Your race copter has four rotors, two of which turn clockwise and the other two anti-clockwise.
• These two types (marked A and B in Fig. 4) of rotors use blades of opposite types since each of the two pairs of
blades is designed to work in a different direction of turn.
• To remove the rotor blade it need to be pulled up.
• Placethenewrotorbladeontothemotorshaft.Makesurethenewrotorbladeissecurelyxed.
Fig. 4
A
A
B
B
Pull up the rotor
blade to remove