Instructions

29
c) Binding the Transmitter with Race Copter
The transmitter uses a 2.4 GHz transmission frequency and achieves a transmission range of up to approx.
60 metres, depending on the environment and ambient conditions.
• Checkthattheightbatteryischarged.Connecttheightbatterytotheracecopter.ThePowerLED(2)willstart
toash.
• Placetheracecopteronaatsurface.
• Set the ON/OFF switch (8) to position ON to turn on the transmitter.
• Turn the left throttle/rudder control stick (1) downwards to the lowest position.
• TheracecopterwillbeepandthePowerLED(2)willconstantlylightup.Thisconrmsthatbindingiscompleteand
the race copter is ready for take-off.
d) Video transmission channels
The race copter can transmit a 5.8 GHz video signal to a compatible FPV-monitor (not included). You need an FPV-
monitor for video transmission. The following table shows suitable channels with relevant DIP switch (S1 - S5) settings.
Setting S1 S2 S3 S4=ON, S5=ON S4=OFF, S5=ON S4=ON, S5=OFF
MHz MHz MHz
DIP switch position /
frequency
OFF OFF OFF 5725 5880 5866
ON OFF OFF 5745 5860 5847
OFF ON OFF 5765 5840 5828
ON ON OFF 5785 5820 5809
OFF OFF ON 5805 5800 5790
ON OFF ON 5825 5780 5771
OFF ON ON 5845 5760 5752
ON ON ON 5865 5740 5733
The DIP switches are situated at the bottom of the race copter below the battery compartment. DIP switch no. 6
is having no function. Follow the above table for DIP switches 1 - 5 to adjust the video transmission frequency, if
necessary. For position of DIP switches see Fig. 2.
e) Race timer function
The other DIP switch line with switches 1 - 3 are for the race timer address code setting as per table below:
DIP switch position 100 010 001 101 111 110 011 000
Channel 42385 42920 42590 42728 44454 43025 44361 44451
The race timer signal will be transmitted with an IR-signal. The transmission range is 1.5 m. The IR-emitter is situated
at the top of the race copter. See Fig. 3.