Instructions

• Ifyoupullthecontrolstickfortheelevatorandthenunittotheright,thenunitmustdeecttotheright.This

pushesthelandinggeartotheleftinightandthemodelwillrollaroundthelongitudinalaxistotherightduetothe

changedowsituationonthewings.

• You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.

Figure 13

• Aftercompletingthetest,rstturnoffthemodelandthenthetransmitter;removetheightbatteryfromthemodel.

g) Mounting the propeller

• If you look at the model from the rear, the motor turns

the propeller (1) clockwise.

• Place the propeller on the catch (2) so that it propels the

air backwards in the rotation direction described above.

• The propeller tappet is secured on the motor shaft with

a grub screw. The model includes a suitable hex key to

tighten the grub screw.

• A suitable wrench is enclosed to attach the propeller

nut (3).

Figure 14