Instructions

44
• Ifyoupullthecontrolstickfortheelevatorandthenunitupwards,theelevatorunitmustdeectdownwards.In
ight,thelandinggearisthenpressedupwardsandthemodeldescends.
• This control function is required to put the model into a normal light position if it wants to ascend too much due to
a control error or a gust of wind.
Figure 11
• Ifyoupullthecontrolstickfortheelevatorandthenunittotheleft,thenunitmustdeecttotheleft.Thispushes
thelandinggeartotherightinightandthemodelwillrollaroundthelongitudinalaxistotheleftduetothechanged
owsituationonthewings.
• You have to slightly pull on the elevator so that the model does not loose any height in this slanted position.
• If the rudder reacts opposite to the function described above, you may change the direction of the rudder servo with
thereverseswitch(seegure2,pos.7).Thereisaseparateswitchforeachcontrolchannel.Therudderdirection
is switched with the outer left switch (CH1).
Figure 12