Instructions

42
c) Installing the main landing gear
• The main landing gear (1) is slid from below into the
prepared shaft on the bottom of the fuselage (2).
• To do so, press the two wheels slightly together and
slide the wire into the shaft.
• Then you can let the wheels spring back. The landing
gear is then safely suspended in the shaft by the spring
force of the wire.
d) Installing the ight accumulator
• Youhavetotakeoffthecabinhood(1)toinserttheight
accumulator. To do so, press the latch (2) forward and
lift the hood off forward on the front.
• The hood is maintained in place in the rear by another
latch that snaps in beneath the fuselage wall.
 When putting on the hood, you rst have to
slide in the catch beneath the side wall of the
fuselage before securing the hood again with
the front latch.
• Prior to connecting the accumulator to the model, you
have to check whether the function switch on the model
(3) is in the rear position (OFF).
• Insertthechargedightbattery(4)intothebatterycom-
partment and connect it with the plug-type connection
(5)oftheightcontrol.
• Onceagain,thelatchesoftheightcontrolplugmust
engage in the groove of the accumulator plug the same
way as with connection to the charger.
Our tip:
Generally, it is not required to additionally se-
cure the ight battery in the model, because
the battery is retained by the fuselage parts. If
these clamps slacken over the course of time,
youcanattachtheightbatterywithabitofVel-
cro tape or rubber rings.
Figure 7
Figure 8