Instructions

42
Whenthetransmitterisswitchedon,thegreenfrequencyLED(F)ontherightalsoashestoindicatethatthetrans-
mitter is in pairing mode. In pairing mode, the transmitter attempts to connect to the receiver in the ready-to-start
model boat (the boat battery must be connected). After a few seconds (if pairing was successful), the green frequency
LED (F) will stay constant.
Atrimmer(G)islocatedbetweenthetwoLEDs.Usethetrimmertosetthemaximumpossiblerudderdeection(dual
ratefunction).Turnthetrimmertotheleftasfarasitwillgotosettherudderdeectiontotheminimumsetting.Toset
therudderdeectiontothemaximumsetting,turnthetrimmertotherightasfarasitwillgo.
Theruddersystemhasamechanicalstop.Whenusingtheabove-describedtrimmer(G)tosettherudderdeection,
ensurethattherudderwillnotblocktheservoatthemaximumdeectionsetting.
Use the upper trimmer (H) to set the neutral position of the rudder. For example, if the model boat moves to the left
when the steering wheel (A) is in the neutral position, move the trimmer (H) to the right.