Instructions

44
Example:
Set ball-head screw (A and B) Tighten/loosen plastic grub screw (C)
Set camber more negatively:
Turn upper ball-head screw (A) to the right clockwise, and the lower ball-head screw (B) to the left counter-clockwise
(withsmall2.5mm-hexagonwrench(D)each).
Set camber more positively:
Turn upper ball-head screw (A) to the left counter-clockwise, and the lower ball-head screw (B) to the right clockwise
(withsmall2.5mm-hexagonwrench(D)each).
 Twistthetwoball-headscrews(A)and(B)withthesmall2.5mmhexagonwrench(D)inoppositedirections
(!) at all times and always by the same angle (e.g. a quarter turn to the left or right).
We recommend always changing the setting only by a quarter turn at a time and then reviewing the driving
behaviour.
 Thesmallhexagonholeoftheball-headscrews(A)and(B)isonlyvisiblewhenlookingrightthroughthe
largehexagonholeoftheplasticgrubscrews(C).
 Donotturnouttheball-headscrewstoofarsincetheaxlestubwillnolongersticktothetransverselink
otherwise.
Thencheckthatthewheelsuspensioncanbemovedfreely(thewheelcanextendanddeect).Ifthisisnotthe
case,loosentheplasticgrubscrews(C)withthelarge5mm-hexagonwrench(E);forthis,turnitasmallbittothe
left counter-clockwise.
Iftheaxlestubiswobblyatthetransverselinks,turntheplasticgrubscrews(C)intotherightclockwisewiththelarge
5mm-hexagonwrench.Donotapplyanyforce,asdescribed,sincethewheelsuspensioncannotmoveotherwise
andthewheelthuscannotextendordeect.