Instructions

• Function #4, the green LED ashes briey four times: starting mode by driving away

Depending on the setting, drivie off is performed with more or less force. The higher the setting value, the more

powerthemotordrawsfromtheconnectedbattery;itsqualityhastobeaccordingly.

A higher setting value should also be used on loose surfaces, otherwise an overload of the drive (gearbox,

differential) occurs.

• Function #5, the green LED ashes briey ve times: maximum braking force

Depending on the position of the transmitter‘s lever, the speed controller provides a proportional braking force. The

maximumbrakingforceatfulldeectioncanbesetbetween25%,50%,75%and100%.

A high setting value (e.g. 100%) reduces the braking distance, but has a negative effect on the drive‘s service life

(specicallyforthedrivepinionandthemaingear).

c) Resetting the speed controller

This option allows you to reset all the settings that you have made in the speed controller‘s set-up to the factory setting

(see the grey markings in the table in Chapter 10. b).

Proceed as follows:

• Turn on the transmitter. Let the throttle/brake lever in the neutral position, do not move it.

• Turn on the speed controller (by moving the slide switch toward the set-up button). Now, the vehicle should be ready

foroperation;onthespeedcontrollernoLEDison.

• Holddowntheset-upbuttonforalongerperiod,untiltheredandgreenLEDsashslowly,simultaneously.

• Nowturnoffthespeedcontroller(„OFF“position;seeimageChapter10.a)orb).Thereupon,allsettingsarereset

tothedefaultsettings;seetableinChapter10.b).

• For reprogramming the speed controller, please refer to the previous Chapter 10. a) and b).

Important!

If a LiPo battery as drive battery is used, you should check the basic setting of the speed controller to see if

the undervoltage protection is activated (normally 3.0 V/cell). Otherwise, when the undervoltage detection

is turned a deep discharge of LiPo battery occurs, which destroys it.

If a NiMH drive battery is used, you should disable the undervoltage detection or set it to a lower value

comparedtoftheLiPobattery;seeChapter10.b),function#3.