Instructions

48
b) Programming the special functions
The speed controller comes preprogrammed with the most practical default factory settings.
If a LiPo battery as drive battery s used, you should check the basic setting of the speed controller to see
if the undervoltage protection is activated (normally 3.0 V/cell). Otherwise, when undervoltage detection is
turned off, a deep discharge of LiPo battery occurs, which will destroy it.
If a NiMH drive battery is used, you should disable the undervoltage detection or set it to a lower value
compared to the LiPo battery.
Programming can be performed very easily via the set-up button.
Proceed to programming as follows:
• Turn on the transmitter, if not done so already.
• Turn off the speed controller („OFF“).
• Pressandholddowntheset-upbutton(B)nexttothe
on/off switch (A) and then turn on the speed controller
(„ON“).
Continue to hold down the set-up button (B), do not
release it.
• Onthespeedcontroller,theLEDashesredandthe
motor generates beep tones (continue to hold down the
set-up button).
• Aftersometime,theLEDashesingreen(continuetoholddowntheset-upbutton).
Thenumberofthegreenashingsignals(1x....5x)indicateswhichsettingfunctioniscurrentlyselected.
LEDashes1xgreen+1beeptone: drivingfunctionforward/backwardorforwardonly
LEDashes2xgreen+2beeptones: motorbrake
LEDashes3xgreen+3beeptones: undervoltagedetectionforLiPo
LEDashes4xgreen+4beeptones: startmodeatdriveoff
LEDashes5xgreen+5beeptones: brakingforce
The beep tones are generated by a short activation of the brushless motor. However, depending on the
motor, this beeping is very low. Then, please pay attention to the LED display on the speed controller.
• When the desired mode,which you want to change is displayed (e.g. undervoltage protection, the LED blinks three
times green + three beep tones from the motor), release the set-up button.
• NowtheLEDashesagaininred.Thenumberofredashingsignalsshowsyouwhichsettingvalueisactive(e.g.
undervoltageprotection3.0V/cell,LEDashesbrieyfourtimesinred+fourbeeptonesfromthemotor).
• Bypressingbrieytheset-upbutton,youcanchangethesettingvalue,thenumberofredashingsignalsofthe
LED (and the beep tones from the motor) change accordingly.
• Toexitthesettingmodeandtosavetheconguration,turnoffthespeedcontroller.Afterwardsitisreadywiththe
new settings when you turn on again the speed controller.
• When another setting needs to be changed, proceed again as described above.