Instructions

47
10. Programming the speed controller
a) Programming the neutral and full throttle position
If the vehicle does not remain steady when in the throttle/brake lever’s neutral position, you can adjust the trimming
forthedrivingfunctiononthetransmitter.Ifthetrimmingpathisnotsufcient(orifthetrimmingisalreadyalmost
at the end of the trimming path), you can reprogram the neutral position and the full-throttle positions for forward/
backward driving.
To do this, proceed as follows:
• Turn on the transmitter, leave the throttle/brake lever in neutral position. Set the trimming for driving function to the
middle position.
• Press and hold the set-up button (B) and turn on the
speed controller by the slide switch (A) („ON“).
• Thereon,theLEDashesredonthespeedcontroller
and the motor beeps. Release again the set-up button.
If you do not release the set-up button, the programming
mode will be activated (see Chapter 10. b) after a few
seconds. In this case, turn off the speed controller and
proceed once more as described above.
• Release the throttle/brake lever on your transmitter, so
that it is in the neutral position.
• Pressbrieytheset-upbutton(B),theLEDonthespeedcontrollerwillbrieyashonceingreen;youcanalsohear
a beeping tone. The neutral position is stored.
The beep tones are generated by a short activation of the brushless motor. However, depending on the
motor, this beeping is very low. Then, please pay attention to the LED on the speed controller.
• For forward drive, move the throttle/brake lever on the transmitter into the full throttle position, pull it towards the
handlepieceandholdittherermly.
Attention!
If you do not move or you do not move the throttle/brake lever of the transmitter far enough during program-
ming, it may happen that the vehicle already responds to tiny movements of the transmitter’s throttle/brake
lever or becomes uncontrollably after programming is complete. Then redo programming.
• Pressbrieytheset-upbutton(B),theLEDonthespeedcontrollerwillbrieyashtwiceingreen;youcanalsohear
two beeping tones. The full throttle position for forward driving is stored.
• Move the throttle/brake lever to the full throttle position for backward driving, push it away from the handle until it
stops.
• Pressbrieytheset-upbutton(B),theLEDonthespeedcontrollerwillbrieyashthreetimesingreen;youcan
also hear three beeping tones. The full throttle position for backward driving is stored.
• Release the throttle/brake lever, so that it is in the neutral position again. Now wait at least 3 seconds, then the
settingmodeisexitedautomaticallyandthespeedcontrollerisoperationalwiththenewlymodiedsettings.