Instructions

42
9. Start-up
a) Removing the vehicle body
Pull out the four securing clips and remove the vehicle body upwards.
b) Installing the receiver‘s antenna cable
Pass the antenna cable through the supplied antenna tube
and plug it into the corresponding holder on the top of the
receiverbox;seearrowintheimageontheright.
Foralargecoverage,itisnecessarythattheantennaext-
ends as vertically as possible from the vehicle.
It is possible that upon delivery of the vehicle the antenna
cableisstillinthereceiverbox.Inthiscase,openthere-
ceiverboxbypullingoutthesecuringclips,sothatthelid
ofthereceiverboxcanberemoved.
Make absolutely sure that the antenna cable
is not damaged. Never shorten the antenna
cable! Never wind the antenna cable! This re-
duces the coverage immensely!
c) Installing the battery/rechargeable battery in the transmitter
Open the battery compartment of the transmitter and insert either the conventional batteries or fully charged rechar-
geablebatteries.Payattentiontothecorrectpolarity(plus/+andminus/-);seelabelinthebatterycompartment.Close
the battery compartment again.
Note the separate operating instructions accompanying the remote control system.
d) Commissioning the transmitter
Turn on the transmitter and set the trimming for the steering and driving function respectively to the middle position.
If the transmitter features a dual rate function, this must be disabled or adjusted so that the steering lock is not
restricted.
Observe the separate operating instructions accompanying the remote control system.