Instructions

67
d) Rechargeable Battery Type
Independentlyofthesettingofthebatterytype(NiMHorLiPo),theconnectednumberofcellsisdeterminedauto-
matically.Whenprogramming"LiPo"(assumingtherechargeablebatteryisfullycharged),therstsoundsequence
signalsthecellnumberafterconnectionoftherechargeablebatterytotheightcontroller(e.g.threesoundsfora
3-cellLiPorechargeablebattery).Whentherechargeablebatterytype"NiMH"isprogrammed,thecellnumberwill
not be signalled.
Toavoidharmfuldeepdischargesofthebattery,themotor'soutputisreducedmatchingthecellnumberandbattery
time or the motor switched off in time by a programmed undervoltage recognition (characteristic programmable, see
item e)= "Deactivation Behaviour at Undervoltage").
The rechargeable battery type can be programmed as follows:
• Switch the transmitter on and then put the throttle lever for motor control to the full throttle position.
• Thenconnecttheightbatterytotheightcontrolleragain.
• Theightcontrollerwillswitchtoprogrammingmodeaftervarioussignalsoundsandstartwiththerstprogram-
mingitem,"Motorbrake".Thisisindicatedbyabriefsignalsound.Waituntilyouheartwobriefsignalsounds.Now
pull the control lever for the motor control back all the way (position "Motor off").
• Theightcontrollersignalsthesettingoptionswithanendlessloop.
- One signal sound = LiPo rechargeable battery
- Twosignalsounds=NiMHrechargeablebattery
• To save, set the control lever for the motor control to full throttle at the desired setting.
e) Deactivation Behaviour at Undervoltage
Selecthowtheightcontrolleristoreactifundervoltageisrecognised.Select"reduction"toreducemotorpowerwhen
the undervoltage limit is reached. Select "deactivation" to deactivate the motor completely when the undervoltage
limit is reached.
The deactivation behaviour at undervoltage can be programmed as follows:
• Switch the transmitter on and then put the throttle lever for motor control to the full throttle position.
• Thenconnecttheightbatterytotheightcontrolleragain.
• Theightcontrollerwillswitchtoprogrammingmodeaftervarioussignalsoundsandstartwiththerstprogram-
ming item, "Motor brake". This is indicated by a brief signal sound. Wait until you hear three brief signal sounds.
Nowpullthecontrolleverforthemotorcontrolbackalltheway(position"Motoroff").
• Theightcontrollersignalsthesettingoptionswithanendlessloop.
- One signal sound = reduce power at undervoltage
- Two signal sounds = switch off motor at undervoltage
• To save, set the control lever for the motor control to full throttle at the desired setting.
If undervoltage is displayed by reducing the motor output or deactivation of the motor, the motor can be
switchedonagainafterbrieyputtingthecontrolleverto"Motoroff".However,thisshouldonlybeusedin
exceptions(topreventacrash),sincethereactivationmaydeep-dischargetheightbatteryanddamage
it.