Instructions

66
b) Position "Motor off"
Theightcontrollerautomaticallyrecognisesthecontrolsignalofthetransmitterformotorcontrol.If,forexample,the
controlleverforthemotorcontrolisnotinthe"Motoroff"positionwhentheightbatteryisconnected(controllever
is not pulled all the way back to the body), the current position of the control lever may be recognised as an error.
Inthiscase,theightcontrollerwillemitthreesignalsinquicksequenceandinterruptsinitialisationoftheightcon-
troller.Onlywhenthecontrolleverofthetransmitterisfullypulledbackwilltheelectronicsswitchtheightcontroller
to operating mode and recognise the control lever position (at the very rear) as "Motor off".
Whenthecontrolleverforthemotorcontrolispushedallthewaytothefront(awayfromyou),theightcontroller
switches to programming mode. There will be a small melody followed by a double signal sound (2 beeps).
Nowpullthecontrolleverforthemotorcontrolbackallthewaytotherearposition.Theposition"Motoroff"isthen
programmed.
DependingonthenumberofcellsthatarerecognisedintheLiPobattery,theightcontroller'sreadinessforoperation
is signalled by two brief signal sounds (two-cell rechargeable battery was recognised) or by three brief signal sounds
(three-cell rechargeable battery was recognised), followed by a longer signal sound.
Always observe that the control lever at the transmitter for the motor control is pulled back all the way
(towardsyou)whenconnectingtheightbattery.Afterprogramming"motoroff",nofurtherprogrammingis
possible. If necessary, restart programming.
c) Motor Brake
Theightcontrollerhasanintegratedmotorbrake.This"EMKbrake"stops(brakes)themotorimmediatelyafterthe
control signal "Motor off".
Thismotorbrakekeepsthemotorfromrunningalonganymoreduetotheairowingthroughthepropellerinight,
and the folding propeller may fold in. This reduces air resistance in pure gliding.
The motor brake can be switched on and off as follows:
• Switch the transmitter on and then put the throttle lever for motor control to the full throttle position.
• Thenconnecttheightbatterytotheightcontrolleragain.
• Theightcontrollerwillswitchtoprogrammingmodeaftervarioussignalsoundsandstartwiththerstprogram-
mingitem,"Motorbrake".Thisisindicatedbyabriefsignalsound.Nowpullthecontrolleverforthemotorcontrol
back all the way (position "Motor off").
• Theightcontrollersignalsthesettingoptionswithanendlessloop.
- One signal sound = motor brake deactivated
- Two signal sounds = motor brake activated
• To save, set the control lever for the motor control to full throttle at the desired setting.