Instructions

65
13. Programming the Flight Controller
 Thefollowingchapterswillonlyshowprogrammingintheabbreviatedform.Fordetailedinformationon
programming,seethefollowingitem"GeneralNotesonProgramming".
a) General Notes on Programming
Theightcontrollerinstalledinthemodelisprogrammableandcorrectlysetexworksfortheightmodel.
Deviatingfromthefactorysettings,thefollowingcanbeprogrammed:
• Position "Motor off"
• Motor brake
• Rechargeable battery type
• Deactivation behaviour at undervoltage
• Undervoltage recognition
• Starting behaviour
• Motor timing
• Restoring Default Settings
To get to the programming mode, switch on the transmitter, push the control lever for the motor control all the way
tothefrontandconnecttherechargeablebatterytotheightcontroller.Therewillbeasmallmelodyfollowedbya
doublesignalsound(2beeps).Afteranotherapprox.veseconds,therewillbeanothermelody.
The signal sounds are generated by brief activation of the electric motor.
Theightcontrollerisnowinprogrammingmodeandgoesthroughallsettingoptionsinanendlessloop.Thefurther
programme items are described in the following sub-chapters "a" to "i" in the order in which they occur in the program-
mingmodeoftheightcontroller.
When you have reached the programme item you want to change, pull the control lever for the motor control all the
way to the back.
The respective submenus offer two or three options that are signalled to you by the corresponding number of signal
sounds. In order to save the desired setting from the submenu, switch the control lever for the motor control into the
top position. There will be a brief melody ("dida dida dida"); this signals storage of the chosen setting value.
If you do not want to perform any further programming, put the control lever for the motor control into the bottom-most
position now (motor off). The speed controller is ready for operation after initialisation.
If you want to change any further program items, keep the lever at the transmitter for the motor control in the front-
most position (full throttle) and continue programming as described above (not possible for programming the position
"Motor off").