Instructions

54
d) Checking the Linkage Rods at the Ailerons
The linkages of the ailerons are pre-installed ex works. Also check if the rudder horns of the linkage rods are in the
second-to-last, outer position of the rudder horns.
In the neutral position of aileron trimming and control lever at the transmitter, the ailerons need to be in the neutral
positionaswellandendushwiththerearwingedge.Ifthisisnotthecase,theaileronsmustbeadjustedbytwisting
the clevises in or out.
The connection of the aileron servos is described in the chapter "Mounting the Wings". The correct function is ex-
plainedinchapter"CheckingtheControlFunctions".
Figure 16
e) Securing the Wings for Flight Operation
Thetsofthewingandwingholderatthefuselagedonotensuresufcientfasteningforightoperation.
Therefore,thewingsareadditionallysecuredwithonescreweachthatclampsthewingrod.Forthis,carefullyturn
the screws clockwise until secure clamping is ensured, but the wing rod or its latch is not damaged by too-strong
tightening.