Instructions

47
9. Model Setup
 ThereferencesintheoperatinginstructionsrefertothescopeofdeliveryoftheRTFversionwithitemno.
1517960.IfyoupurchasedthePNPversionwithitemno.1517327,nocharger,noightbatteryandno
remote control are enclosed. However, you can use these operating instructions as a reference for place-
ment and connection of those components and install your own components there.
Before assembling the model, please read each individual section carefully. The construction stages are
illustrated for better understanding.
 Fordesignandcolourofyourmodelandtheremotecontrol,usetheillustration,e.g.onthepackagingfor
reference.Designandcolourdeviationsintheseoperatinginstructionsarepossible.Theguresinthese
operating instructions only serve illustration.
Only carry out the steps described in the different sections if you have completely understood the proce-
dure and know exactly what to observe.
 Liftoffthecanopyforthefollowingwork.Itisfastenedtothefuselagewithamagnet(alsoseegure17,
item 3). To lift it off, pull the canopy up a bit vertically at the rear end.
a) Mounting the Elevators and Rudders
FirstplacetheelevatorontheprovidedsupportandscrewitontothefuselagewithaM4x25screw(seegures
1+2).Imprecisetsshouldbecarefullycorrectedwithacutterknifeand/ornesandpaper.
Figure 1 Figure 2