Instructions

46
• Observecorrectpolaritywheninsertingbatteriesintothetransmitterorconnectingtheightbatteryto
theightcontroller(positive/+andnegative/-).
Incorrectpolaritywilldamagenotonlythetransmitterbutalsotheightmodelandtherechargeable
battery.Thereisadangerofreandexplosion.
• If you do not use the model for an extended period of time (e.g. during storage) remove the batteries
(or rechargeable batteries) inserted in the remote control to avoid damage from leaking batteries. Also
disconnecttheightbatteryfromtheightcontroller.
• Donotleavetherechargeableightbatteryconnectedtotheightmodelifthelatterisnotused(e.g.
duringtransportorstorage).Otherwise,theightbatterymaybefullydischargedandisthusdestroyed/
unusable!
• Recharge the rechargeable batteries about every 3 months. Otherwise, so-called deep discharge may
result, rendering the rechargeable batteries useless.
• Alwaysreplacetheentiresetofbatteriesorrechargeablebatteriesinthetransmitter.Nevermixfully
charged batteries/rechargeable batteries with partially discharged ones. Always use batteries or re-
chargeablebatteriesofthesametypeandmanufacturer.Nevermixbatteriesandrechargeablebat-
teries!
• When handling LiPo batteries, observe the special safety information of the battery manufacturer!
8. Charge Rechargeable Battery
ThereferencesintheoperatinginstructionsrefertothescopeofdeliveryoftheRTFversionwithitemno.
1517960.
IfyoupurchasedthePNPversionwithitemno.1517327,nochargerandnoightbatteryareenclosed.In
thatcase,usethesafetynotesoftherechargeablebattery'smanufacturersandthemanufacturer'sinstruc-
tions of the charger you use as a reference for charging a rechargeable battery.
Beforethenalassemblyof themodel, youshouldcharge theight battery.Anappropriatebalancerchargeris
included in the delivery.
The 2-wire connection cable at the rechargeable battery supplies the drive motor with power. This cable is connected
totheightcontrollerinthemodellater.
The rechargeable battery is charged via the 4-pole connection cable, which is connected to the left output socket of
the balancer charger.
Forthis,observetheinstructionsintheoperatinginstructionsofthecharger.