Instructions

48
• Ifyoupullthecontrolleverfortherudderandelevatorfunctions(seegure2,pos.4)down,theelevatormust
deecttothetop.Inight,thelandinggearispresseddownwardsandthemodelascends.
• If the elevator reacts opposite to the function described above, you may change the direction of the elevator servo
withthereverseswitch(seegure2,pos.7).Thereisaseparateswitchforeachcontrolchannel.Theelevator
direction is switched with the 2nd switch from the left (CH2).
Figure 14
• Ifyoupushthecontrolleverfortherudderandelevatorfunctions(seegure2,pos.4)up,theelevatormustdeect
downwards.Inight,thelandinggearisthenpressedupwardsandthemodeldescends.
• This control function is required to put the model into a normal light position if it wants to ascend too much due to
a control error or a gust of wind.
Figure 15