Instructions

47
g) Suspending the rudders
• After you have checked resp. adjusted the correct posi-
tion of the servo levers, you can now suspend the fork
heads (1) of the control rods each in the center boring of
the rudder horns (2).
• Now check whether the rudders are exactly in the cen-
tral position while the transmitter and receiver unit is
turned on.
Therudder(3)mayneitherdeecttotheleftortheright
and the elevator unit (4) may not point upwards or down-
wards(alsoseegure13).
• In case of deviation from the central position, you can
change the total length of the control by twisting the fork
headsandexactlyaligntherudderap.
Warning!
Make sure to turn the receiver system off in all cases before performing adjustment work on the control
rods.
Practical tips:
 Youcanbestseeaslantoftherudderapsofyoulookatthemodelfrombehindatadistance.
h) Checking the rudder functions
• First start running the transmitter then the model. The safety button for the motor function may not be operated to
prevent accidental start-up.
• Ifthecontrolleverfortherudderandelevator(seegure2,pos.4),andtheassociatedtrimlevers(seegure2,
pos.3and5)areinthemiddlepositions,therudder(seegure13,pos.1)andelevator(seegure13,pos.2)are
to be aligned precisely centred as well.
Figure 13
Figure 12