Instructions

45
d) Mounting the Fin
• Then(1)isslidfromaboveintotheunitholderand
aligned.
• Therearedgeofthendampenermustbeushwith
the rear edge of the elevator unit damping surface (see
broken line).
Important!
 Then(1)mustalsobeata90°angletothe
elevator unit (3) (see sketch).
• Oncethenisexactlyaligned,attachitfromtheleftside
with the two 2 x 10 mm screws (2).
e) Installing the ight accumulator
• Youhavetotakeoffthecabinhood(1)toinserttheight
accumulator. To do so, press the latch (2) forward and
lift the hood off forward on the rear.
• The hood is maintained in place in the front by another
latch that snaps in beneath the fuselage wall. When
puttingonthehood,yoursthavetoslideinthecatch
beneath the side wall of the fuselage before securing the
hood again with the front latch.
• Prior to connecting the accumulator to the model, you
have to check whether the function switch on the model
(3) is in the rear position (OFF).
• Insertthechargedightbattery(4)intothebatterycom-
partment and connect it with the plug-type connection
(5)oftheightcontrol.
• Onceagain,thelatchesoftheightcontrolplugmust
engage in the groove of the accumulator plug the same
way as with connection to the charger.
Figure 9
Figure 10