Instructions

20
d) Flip Function
The model can perform a ip (a 360° turn). For this, put the quadrocopter into a
stable hover ight at an altitude of at least 1.5 metres at sufcient distance from
the pilot and any obstacles.
Push the right control stick vertically down (push the control stick like a button).
The transmitter will emit a control sound at an even rhythm to conrm that you
have chosen ip mode. The control sound will remain activated until the ip is
completed.
Now, briey put the right control lever in the direction in which the ip is to take
place.
Examples: If you push the right lever forward, the quadrocopter will turn over forwards. If you push the right lever
backward, the quadrocopter will turn over to the right.
After you have specied the ip direction at the transmitter, put the right control lever into the neutral position again
at once.
Attention!
The ip function generally must only be used if the model is own in a large hall or outdoors, is in a stable
ight condition (hovering) before the respective operating button is pushed at the transmitter, the ight
height is not below 1.5 metres and the quadrocopter is at least 5 metres away from obstacles and persons.
If this is not observed, there is a danger of damage to the model or other objects nearby and a danger of
injury to persons/animals in the vicinity from contact or crash! We recommend performing the rst ops in
the rising movement of the quadrocopter.
When the model is already in "Low Batt mode" (front LEDs at the quadrocopter ash), the ip function is
deactivated for reasons of safety and therefore cannot be performed.
The model can perform a ip function only in one direction (only forward or backward; only to the left or
right) and therefore also requires the corresponding clear control commands from the transmitter (right
control lever forward or back; right control lever to the left or right). Therefore, avoid inadmissible control
commands when the ip function is activated, such as "right control lever pushed to the front+left". In such
cases, there may be uncontrolled ight conditions and crashes.
After a ip, the function is automatically deactivated at the transmitter. If you want to perform another ip,
you need to activate the ip function at the transmitter rst.
Figure 11