Instructions

43
Rudder function
Ifthecontrolstickfortherudderfunctionismovedtotheleft,theruddermustdeecttotheleft.Therearrudderedge
mustbedeectedtotheleftbyapprox.15mm.Inight,thelandinggearispressedtotherightandthemodelies
to the left.
Figure 14
Ifthecontrolstickfortherudderfunctionismovedtotheright,theruddermustdeecttotheright.Therearrudder
edgemustbedeectedtotherightbyapprox.15mm.Inight,thelandinggearispressedtotheleftandthemodel
iestotheright.
Figure 15
 Iftherudderdoesnotdeectasdescribedabove,the„Servo-Reversefunction“atthetransmittermustbe
usedtochangetherunningdirectionoftheservos.Furtherinformationonthiscanbefoundintheoperating
instructions for the remote control.
Motor Function
Attention!
 Ensurethatnolooseparts,suchaspaper,lmorotherobjectscanbesuckedintotherotorduringthis
motor test. Also make sure that the model is held securely during this test run and that no clothing and body
parts are within the rotation range or danger area of the rotor.
Push the control lever for the motor function to the bottom position (motor off).
Start up the transmitter and then the model.
Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and
increase speed depending on control lever position.
Figure 16