Instructions

Important!

Always measure the centre of gravity with the cabin hood in place.

 Fortherstights,setthecentreofgravityatapprox.49mmwingdepth.Thebestcentreofgravitythen

can be reset slowly.

e) Checking the Control Functions

Beforestartingyourmodelforthersttime,youneedtofamiliariseyourselfwiththeremotecontrol,thecontrolfunc-

tions and test the model functions. The functions and commissioning of the remote control system can be taken in the

operating instructions enclosed with the remote control.

Alwaysturnonthetransmitterrstandputthespeedcontrolleverto„Motoroff“.Connecttheightbatterytotheight

controller(seegure8,item6).Theightcontrollernowteststhecontrolsignalfromthetransmitter„Motoroff“and

acousticallyreportsthiswithsignalsounds.Theightcontrollerisnowreadyforoperation.

 Theightcontrollerisalreadycorrectlyprogrammedexworks.Formoreinformationontheightcontroller,

seethechapter„Programmingtheightcontroller“.

 Thesignalsoundsaregeneratedbyashortstart-upofthemotorbytheightcontroller.

 Theightcontrollerhasanundervoltagerecognitionthatreducesthemotoroutputordeactivatesthemotor

at a voltage below 3.0 V per cell (for the rechargeable battery in the model plane. below 6.0 V). Thus a

harmful deep discharge of the battery is avoided.

Neutral Position

When the control lever for the rudder, elevator and aileron functions and the trimming of the control functions is pre-

ciselyinthecentreposition,therudder,elevatorandaileronattheightmodelshouldbepreciselycentred.Viewed

fromtherear,theruddersandelevatorsmustformalevelwiththerudderandmustnotbedeectedtothetopor

bottom, left or right. The ailerons must be at one level with the wings.

If the ailerons and/or rudders or elevators are not aligned precisely, the rudders can be aligned precisely with the

linkage wires by twisting the clevises.

Elevator function

Ifthecontrolstickfortheelevatorfunctionismoveddown,theelevatormustdeecttothetop.Therearrudder

edgemustbedeectedupwardsbyapprox.10mm.Inight,thelandinggearispresseddownwardsandthemodel

ascends.

Figure 10