Instructions

39
d) Mounting the Wing
The wings are installed in the fuselage slots on the left
and right.
Forthis,pushthewingconnector(2)intooneofthewings
(1) so that the V-shape of the wing connector points up.
Push the wing connector (2) into the hole of the fuselage
centre part (hole in the wood receptacle).
Connect the plug of the aileron servo to the socket glued
into the fuselage.
Carefully push the wing against the fuselage until the
shapingofthewingisushwiththefuselage.Ifthewing
cannot be pushed onto the wing connector, turn the safety
screw (4) out step by step at the bottom of the wing.
Observe that the servo cable is pushed into the fuselage
as well and that no large loop can form at the plug connec-
tor(seebottomillustration,gure6).
e) Securing the Wings for Flight Operation
Ifbothwingshavebeenpushedonushwiththefuselage
and the cables of the aileron servos are placed cleanly,
tighten the two safety screws (4) at the bottom of the wings
gently.
Thenchecksecuretofthewingsbytryingtogentlypull
the wings apart again.
Figure 6
Figure 7