Instructions

32
c) Inspecting the ship's propeller
Checktheship'spropelleranditscounter-nutfortighttanddamagebeforeeveryvoyage.Adamagedship'spropel-
ler must be replaced before operation. If this is not observed, the ship's propeller may come loose unintended or break
apart in operation. There is a danger of further damage to your model. The model will also no longer be controllable.
On the ship's propeller, also observe further information in the chapter 10.
Attention!
The ship propeller is very sharp-edged and may cause injury and/or property damage when handling,
replacing and in operation!
d) Setting the trimming aps
Yourmodelhastwotrimmingapsattheleftandrightofthetail(gure2,item6).Thesetrimmingapsservetoopti-
miseslidingofthemodel.Twistingofthesetscrewsslightlyadjuststhetrimmingaps.Afteradjustmentofthescrews,
they must be countered with the nuts and thus protected from independent loosening.
The model sliding properties depend on many factors. For example, the weight and installation site of the
drivebatteryand/orthepropertiesofthewatersurface(manyorfewwaves)inuencethemodelsliding
properties.Therefore,theseoperatinginstructionscantoofferspecicsettinginformation.Youneedto
performoperationteststondthebestsettings.
e) Installation and linkage of the "Turnns"
"Turnns"canbeinstalledattheleftandrightofyourmodel'stailandadjustedslightly(gure2,item7).The"turnns"
areinstalledsothatthesharpedgesofthenspointforwardinrunningdirection.Installed"turnns"improvethedriv-
ing conduct of the model in curves.
During installation or after setting, the screws must be protected from independent loosening with a drop of
threadlocker varnish.
The model's conduct in curves depend on many factors. For example, the weight and installation site of the drive bat-
teryand/orthepropertiesofthewatersurface(manyorfewwaves)inuencethemodelcurveproperties.Therefore,
theseoperatinginstructionscantoofferspecicsettinginformation.Adjustthe"turnns"tothebestsettingforcurves
by running attempts.
Attention!
 The"turnns"areverysharp-edgedatthefrontandmaycausesevereinjuryand/orpropertydamagewhen
handling, transporting and in operation.