Instructions

55
To activate the headless mode, bind the transmitter and quadrocopter to each other (start preparation). The rotors
arestillofffortherstactivation.Nowaligntheready-to-startquadrocopterontheground(ifyoualreadyhavesome
practisethisalsoworksinhoveright)sothatthefront,redrotorspointawayfromthetransmitter(forward).
Now push the left control lever vertically down until a signal sounds and the control LED on the transmitter has switched
togreen.Bothsignalsindicatethatyouarenowinheadlessmode.TwoLEDswillashdiagonallyatthequadrocopter
andthusalsodisplaytheactivatedheadlessmode.Nowstartthequadrocopter.Theightmovementsofthemodel
will always also follow the control directions of the right control lever, no matter the angle of the quadrocopter to the
pilot, when headless mode is activated. If you steer forward, the quadrocopter will move away from you. If you steer
towards the right, the quadrocopter will always move to the right.
To deactivate the headless mode, push the left control lever again until you hear a signal. The LED at the transmitter
islitredagain.ThequadrocoptersignalsdeactivationoftheheadlessmodebybriefashingofallLEDsatthemodel
(only item no. 1530490).
g) Return function
Themodelmayybacktothepilotbypushingabutton.Theprerequisiteforthisisanactivated"headlessmode"(see
priorsection).Toactivatethe"Returnfunction",pushthebutton"Return"(gure3,item8)atthetransmitter.Usethe
right control lever at the transmitter to correct the trajectory. To deactivate the "Return function", you can either push
the button "Return" at the transmitter again or push the right control lever forward (nod).
Attention!
 Thereturnfunctionmustonlybeperformedifthemodelisinastableightcondition(hovering)before
therespectiveoperatingbuttonispushedatthetransmitter,theightheightisnotbelow1.5metresand
the quadrocopter is at least 5 metres away from obstacles and persons. If this is not observed, there is a
danger of damage to the model or other objects nearby and a danger of injury to persons/animals in the
vicinity from contact or crash!
The "Return function" is implemented in the model with relatively simple means (e.g. without GPS-support).
Therefore,deviationsandinaccuraciesinightcoursedeterminationorreturnaccuracyarenormal.
The quadrocopter recognises no obstacles. Therefore, you must ensure that there are no obstacles on a
direct line between the quadrocopter and the transmitter (the return route).