Instructions

31
d) Switching the Helicopter on
Ensure that the model helicopter and the transmitter are switched off.
Then switch on the model helicopter. For this, slide the
on/offswitchofthemodel(1)fromthe"OFF"tothe"ON"
position.
AredLEDinthemodelhelicopterstartstoashinarhythm
of 2. Now put the model helicopter onto the starting point.
Then switch on the transmitter and move the control lever
forthepitchfunction(alsoseegure1,item7)alltheway
forward and back again.
TheredLEDinthemodelhelicopterstartstoicker;after
a brief time, binding is completed and the model helicopter
has recognised and saved the digital code of the transmit-
ter.
The LED in the model helicopter then phases in a rhythm
of 2 again and the model helicopter is ready to start.
The model helicopter must not be turned or moved while binding. Do not operate a second IR remote
control transmitter or a strong light source in direct proximity of the model.
Caution, important!
 Beforestartingtoyyourmodelhelicopter,takenoteofthefollowinginformationrst.
Figure 7