Instructions

24
b) Before Commissioning
• Switchonthehelicopterrstandthenthetransmitter.Thisistheonlywayforanattunementfunction
to take place between transmitter and receiver, so that your model will react reliably to the control com-
mands of your transmitter.
• Check the functional safety of the model and remote control system. Watch out for any visible damage
such as defective plug connections or damaged cables. All moving parts on the model must run smoothly
but must not have any tolerance in the bearing.
• Theightbatteryrequiredforoperation,whichisrmlyinstalledinthemodelhelicopter,mustbecharged
beforeoperationviathetransmitter.Ensurethatthebatteriesinthetransmitterhaveasufcientremain-
ing capacity (transmitter indication). If the batteries are empty, always replace the complete set, never
individual cells only.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends
completely on your responsible use of the model.
• Improper operation can cause serious damage to people and property! Therefore make sure to keep a
sufcientlysafedistancefrompersons,animalsorobjectsduringoperation.
• Nevertrycatchingayinghelicopterwithyourhandandkeepbodypartsandhairawayfromturning
parts such as rotors or gears.
• Flyyourmodelonlyifyourabilitytorespondisunrestricted.Theinuenceoftiredness,alcoholormedi-
cation can cause incorrect responses.
• ArticiallightsourcesorstrongsolarirradiationmayimpairtransmissionoftheIRcontrolsignalsand
clearly reduce the remote control range (usually approx. 10 m).
• Motors,motorregulatorandightbatterycanheatduringoperation.Forthisreason,takeabreakof5to
10minutesbeforerechargingtheightbattery.
• Leave the remote control (transmitter) switched on while the model is in operation. After landing, always
switch off the helicopter before the remote control.
• Never switch off the transmitter while the helicopter is still switched on.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended
period of time.