Instructions

16
f) Adjust servo travel
After installation, if the servo arms are not square / 90° to the
axis of the servo (image A), adjust the servo travel to center
the arm image B).
You will not need to adjust the servo travel again unless the
setup has changed.
• By default, ST.D/R is set to adjust the trim for CH1 (steer-
ing).
• ST.D/R can be reassigned to adjust the servo travel for
CH2 (throttle), CH3, or CH4. For information about how to
reassign, see "g) Multiplexing" on page 16.
• The adjustment range is: 0 to 120% (default 100%), each
step is 5 %.
- Decrease: Press ST.D/R-
- Increase: Press ST.D/R+
Press and hold for rapid adjustments.
1LED indicator
The G.LED:
• Lights up each time an adjustment is made.
• Will not light when the maximum number of adjustments has been reached.
g) Multiplexing
Use this function to assign the ST.TRIM and ST.D/R buttons to different channels.
1. Switch the transmitter POWER ON.
2. Double-press the BIND button to cycle through modes.
Mode G.LED Channel Button Setting
1 1x ash
CH1 ST.TRIM Adjust trim
CH1 ST.D/R Adjust servo travel
2 2x ash
CH1 ST.TRIM Adjust trim
CH2 ST.D/R Adjust servo travel
v 3 3x ash
CH3 ST.TRIM Adjust trim
CH3 ST.D/R Adjust servo travel
v 4 4x ash
CH4 ST.TRIM Adjust trim
CH4 ST.D/R Adjust servo travel
Mode 1 is the default
A B