User manual

38
Pitch function
Thepitchfunctionallowsyoutotiltthemodelhelicopterforwardsandbackwards(seegure11).Thehelicopteris
titled by the electric motor and horizontal propeller on the back of the helicopter. The tail of the helicopter moves up
or down depending on the direction of the tail propeller. In hover mode, the helicopter stays horizontal and the rear
propeller does not rotate.
Thepitchfunctionisalsocontrolledwiththeright-handlever(seegure1,position4).Movingtheleverforwards
raisesthetailandmakesthehelicopteryforwards.Movingtheleverbackwardslowersthetailandmakesthemodel
ybackwards.
Figure 11
g) Practical ight tips for beginners
Althoughthemodelcanbeowninsmallrooms,werecommendusingaunobstructedspaceof3x3mfortherst
fewightattempts.
Position yourself directly behind the helicopter. This ensures that the model reacts to remote control commands (right,
left, forwards and backwards) exactly as you see them. If the cockpit is facing you, the helicopter will respond in the
opposite way.
Important!
If the rotors hit any objects and become trapped, or the model tips over, switch off the rotor motors immedi-
ately.Todothis,pressandholdthestart,landingandmotorstopbutton(seegure12,position7)untilthe
motors come to a standstill.
 Neverattempttostopthemotorswhenthemodelisying,asthiswillcausethehelicoptertofalltothe
ground and may damage the components.
Never attempt to grab the helicopter with your hands when it is in the air, as this may cause an injury.
To prevent the helicopter battery from overdischarging, land the helicopter when the LED on the helicopter
startstoash.
Allow the helicopter battery and model helicopter to cool down before charging or replacing the battery.