User manual
8
b) Before Commissioning
• Switch on the transmitter and then the quadrocopter. This is the only way for an attunement function to take place
between transmitter and receiver, so that your model will react reliably to the control commands of your transmitter.
• Check the functional reliability of your model and of the remote control system. Watch out for any visible damage
such as defective plug connections or damaged cables. All moving parts on the model must run smoothly but must
not have any tolerance in the bearing.
• The ight battery required for operation must be charged before operation. Ensure that the batteries in the trans-
mitter have a sufcient remaining capacity (see transmitter LED). If the batteries are empty, always replace the
complete set, never individual cells only.
c) During Operation
• Do not take any risks when operating the product! Your own safety and that of your environment depends completely
on your responsible use of the model.
• Improper operation may cause serious injury and property damage! Therefore make sure to keep a sufciently safe
distance from persons, animals or objects during operation. Never try to grab the ying model with your hand!
• Fly your model only if your ability to respond is unrestricted. The inuence of tiredness, alcohol or medication can
cause incorrect responses.
• Motors, motor regulator and ight battery can heat during operation. For this reason, take a break of 5 to 10 minutes
before recharging the ight battery.
• Never switch off the remote control (transmitter) while the model is in use. After landing, always switch off the quad-
rocopter before the remote control.
• Never switch off the remote control while the quadrocopter is still in operation.
• Never expose your model or the remote control to direct sunlight or excessive heat for an extended period of time.