User manual

24
12. Flip Function
The quadrocopter is able to y ips as well if desired. The rst ips should be own outdoors on a wind-still day. For
this, rst let the quadrocopter rise to a safety height of approx. 3 - 4 m and then let it hover.
To switch the transmitter to ip mode, push the control
lever for the nod and roll functions from above (also see
gure 1, item 4).
To indicate that the transmitter has switched to ip mode,
it will continually emit brief signal sounds.
Now move the control lever for the nod and roll function
into the direction in which the quadrocopter is to ip quick-
ly to the stop and then return the control lever to the middle
position without delay.
The quadrocopter will perform the ip in the desired direc-
tion and the transmitter will then end ip mode.
For another ip, you need to push the control lever for the
nod and roll function again.
When the LEDs at the quadrocopter ash because the ight battery has dropped below its lower voltage
threshold, the ip function is deactivated.
Figure 15