User manual
13
10. Commissioning of the Quadrocopter
a) Charging the Flight Battery
Caution, important!
The ight battery is rmly integrated in the quadrocopter and cannot be removed for charging. Therefore,
place the quadrocopter on a re-proof underground when charging and do not charge the ight battery
unsupervised.
The ight battery is charged with the enclosed USB charging cable. For this, the charging cable at the quadrocopter is
connected to a USB socket of a computer/notebook or to a conventional USB plug-in charger.
Before rst use, the cable retainer should be opened and the charging cable unwound completely.
Charging:
Connect the plug-in charger of the USB charging cable (1)
to the charging connection at the right side of the quadro-
copter (2) according to the adjacent gure.
Important:
The guide groove of the plug connector (3) must
point down at connection so that it can interlock
with the cut-out at the quadrocopter housing (4).
When connecting the plug, proceed with the re-
quired care and do not apply any unnecessary
force.
Once the USB plug of the charger (5) is connected to a
USB socket of a computer/notebook or a USB plug-in
charger, charging commences automatically.
The red charging control LED (6) in the USB plug is lit and
thus signals charging to you. When charging is completed
and the ight battery is fully charged, the red LED in the
USB plug goes out.
Disconnect the quadrocopter from the charging cable at
once after charging and pull the USB plug of the charging
cable from the computer/notebook or plug-in charger.
Attention!
Do not connect the USB cable to a USB hub
without a separate mains adapter (e.g. a key-
board USB port, etc.), because these will not
provide sufcient current for charging.
Figure 4