User manual

11
9. Setting up the Transmitter
In the further course of these instructions, gures in the text always refer to the adjacent gure or the gures
within the section. References to other gures are indicated with the corresponding gure number.
a) Inserting the Batteries
The power supply of the transmitter requires 3 AAA/micro batteries (e.g. Conrad Item No.: 652278, please order 3x).
Important:
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
Loosen the attachment screw (1) of the battery compart-
ment lid (2) at the back of the transmitter with a suitable
screwdriver.
Push the latching lever (3) of the battery compartment lid
down slightly and fold open the battery compartment lid.
Insert three type AAA/micro batteries into the battery com-
partment according to the indications at the bottom (4) in
the correct polarity. The spiral-shaped spring contact (5)
always must be connected to the minus pole of the battery.
Replace the battery compartment lid in the transmitter
housing and let the latching lever latch.
Then tighten the attachment screw again.
Figure 2