User manual

9. Commissioning

a) Open/Remove Car Body

Pull out the two safety clips (1) at the rear end of the vehic-

le and carefully fold the car body forward.

There is a power cable between the LEDs on the top of the

vehicle and the receiver. Ensure that it is not damaged.

If the cable (2) can be unplugged, pull the associated plug

(3) from the receiver.

Remember the proper alignment (all black cables of the

steering servo, speed controller and LED lamps point to

the same side).

Now the car body can be tipped all the way forward.

To completely disconnect the car body from the chassis,

rstturnoutthetwolittlescrews(4)atthejointbetween

the car body and the chassis with a suitable cross-head

screwdriver.

Then the car body can be removed from the chassis.

During assembly, observe that the plug (3) of the LED lamps is correctly connected to the receiver (all black

cables of the steering servo, speed controller and LED lamps point to one side).