User manual

9
8. Charging the LiPo battery pack
 Insubsequentsectionsoftheinstructions,thenumbersinthetextreferalwaystotheneighbouringFigure
ortotheFigureswithinthesection.Cross-referencestootherFigureswillbespeciedalongwiththeappro-
priate Figure number.
TheLiPobattery packrequired fortheremote controlis generallyincludedin thescope ofdeliveryand mustbe
charged.
Caution, important note!
 ThesuppliedLiPobatterypackmayonlybechargedinthetransmitter.Neveruseanotherchargertocharge
the LiPo battery pack.
 ThechargingcurrentoftheLiPobatterypackmayexceed500mA,forthisreason,chargingconnectedto
the USB port of a computer is not permitted.
Inserting and charging the LiPo battery pack
Thelidofthebatterycompartment(14)islocatedonthe
underside of the transmitter. Press on the corrugated
surfaceandslidethelidoff.Then,inserttheLiPobattery
pack.Slidethebatterycompartmentlid(14)backoverthe
compartment. The lid must click audibly into place.
ConnectaMicro-USBcable(X)totheMicro-USBport(12)
ofthetransmitter.ConnecttheotherendoftheMicro-USB
cable(X) toapluggable powersupply witha USBport.
Only charge the supplied LiPo battery pack in the trans-
mitter,neveruseanotherbatterypack.
The LiPo battery pack is fully charged when the symbol
ofthestatusdisplayofthetransmitterbatterypack(see
Figure10,Number3)iscompletelygreenwhenthetrans-
mitter is switched on.
Status display for transmitter battery pack/receiver battery pack
Battery pack is being charged
Battery pack is fully charged
Figure 1