User manual

49
18. Eliminating faults
Eventhoughthisremotecontrolsystemhasbeenconstructedaccordingtothecurrentstateoftheart,theremaystill
befaultsorproblems.Forthisreason,wewouldliketoshowyouhowtoeliminateanyfaultsthatmayoccur.
Problem Remedy
The transmitter does not res-
pond
• ChecktheLiPobatterypackofthetransmitter.
• Checkthefunctionswitch.
The servos don‘t respond • Checkthebatteriesorbatterypackofthereceiver.
• Testtheswitchingcable.
• ChecktheBECfunctionofthedriveregulator.
• Checkthepolingoftheservoplug.
• Carryoutthebindingfunction.
The servos are trembling • ChecktheLiPobatterypackofthetransmitterandthebatteries/batterypack
of the receiver.
• Dryanydampinthereceivercarefullywithahotairblower.
A servo is buzzing • Checkthebatteriesorbatterypackofthereceiver.
• Checktheeasyofmovementofthesteeringrods.
• Operatetheservowithouttheservoleverfortestpurposes.
The system only has a low ran-
ge
• ChecktheLiPobatterypackofthetransmitterandthebatteries/batterypack
of the receiver.
• Checkthereceiverantennafordamages.
• Positionthereceivingantennainthemodeldifferentlyfortestpurposes.
The transmitter switches itself off
immediately or after a short time
• ChecktheLiPobatterypackofthetransmitterandreplaceifnecessary.