User manual

15.27 “Warning Signals” function

Acoustic Warning Signals

Anumberofacousticwarningsareinstalledintheremotecontrol.Theacousticwarningcan,however,onlybeper-

formed when “Sound” is activated in the submenu of the same name in the menu “System”. The following warning

signals are present:

• Ifthebatteryvoltageatthetransmitterdropsbelow3.75Volt,ahowlingsoundoccurs.

• Ifthebatteryvoltageofthereceiverpowersupplydropsbelowanindividuallyprogrammablevalue,adoublewar-

ning sound “Ba Ba” is output.

• Ifthevoltageofthereceiverpowersupplydropsbelow3.7Volt,aquicksoundsequenceoccurs.

• Iftheerrorrateofthereceiversignalsofthereceiverisabove60%,adoublewarningsound“DuDu”occurs.

• Ifasettimeisreachedinthetransmitter‘stimer,thesoundsequence“BiBiBiBi”sounds

Visual Warning Signals

TheLEDinthetransmitteraerialsignalsdifferentwarningconditions.If“Sound”isactivated,theyareissuedatthe

same time as the acoustic signals.

• TheLEDinthetransmitterisoffwhenthetransmitterisoffandpermanentlylitwhenthetransmitterisonandthe

communication with the receiver is correct.

• IftheLEDashesslowly,thebatterycapacityofthetransmitterbatteryisrunningat.Quicklyinterruptthedriving

operationtoavoidfailureoftheremotecontrolsystemduetotoo-lowbatterycapacity.

• IftheLEDashesquickly,thebatterycapacityofthetransmitterbatteryisrunningat.Immediatelyinterruptthe

drivingoperationtoavoidfailureoftheremotecontrolsystemduetotoo-lowbatterycapacity.

• IftheLEDashesquicklyandthebatteryvoltageofthetransmitterbatteryisstillinexcessof3.75Volt,theerror

rateofthereceiversignalmayexceed60%.Immediatelyinterruptthedrivingoperationtoavoidfailureoftheremote

control system due to bad reception.

• IftheLEDashesquicklyandthebatteryvoltageofthetransmitterbatteryisstillinexcessof3.75Volt,thevoltage

of the receiver battery may be too low. Immediately interrupt the driving operation to avoid failure of the remote

control system due to an empty receiver battery.

15.28 “Change Grip Shell” function

Therearetwodifferentrubbergriphandlesforselectionforbesthandlingofthetransmitter.Forsmallhands,usethe

“gripshellS”,forlargerhands,usethe“gripshellL”.Themark“S”or“L”isimprintedatthebottomofthegripshell.

Carefully lift them starting at the side to replace the grip shells. Use the loose grip shells and the hook shown there

as a reference.