User manual

44
Proceed as follows to update the receiver rmware:
Switch off the transmitter and the receiver.
Plugtheprogrammingplugintothe“BIND”socketofthereceiver.
First switch on the receiver system and then the transmitter.
Atthetransmitter,callthe“RXsetup”menu,andtherethesubmenu“Bindwithareceiver”.Thenleavethesubmenu
again.
Thedisplaywillshow“UpdateReceiver”.Conrmthiswith“YES”.Thedisplaywillchangetoapercentagedisplayand
thus show the progress of the update process.
Iftheupdatehasbeensuccessful,thedisplaywillshow“Successful”.
Nowswitchoffthereceiversystem,disconnecttheprogrammingplugfromthereceiver.
 Afterarmwareupdate,youmayneedtobindthereceivertothetransmitteranew(pairing/bindingproce-
dure).
15.25 “Spectrum analyzer” function
 Thetransmitterwillemit notransmissionsignalswhenthe“Spectrum analyzer”isactivated,andwillbe
inactive.Ifyouselectthisfunction,thereceiversystemmustbeswitchedoffrst.
This function is used to monitor the radio signal. Select the menu “Spectrum analyzer” and then the submenu “Pe-
riod”.
Under“Period”,selecttherecordingperiodoftheradiosignalmonitoring(e.g.“10seconds”).
Thenleave the submenu.The displaywill now showany present transmittersin the rangeof 2.4 GHzand their
signalstrengthsintheperiodof10seconds(endlessloop).Thisfunctioncanbeusedtolocaliseothertransmitters
or interferences.
Theleftscaleshowsthesignalstrengthofasignalreceived.Thehigherthedisplaydeectstowards-60dBm,the
higherthetransmissionoutputofthereceivedtransmitter.Youcanreadthetransmitterfrequencyinthelowerscale.
Ifyoumovethetransmitterintodifferentdirectionsnow,youcangenerallyndthedirectionfromwhichthe(interfe-
rence)transmitterisradiating.