User manual

42
“Failsafe”:
This function permits programming of the servo items that are automatically set when the receiver signal is lost. When
thesettingsaresetto“Off”,theservosremainintheirlastpositionwhenthesignalislost.
This is how you change the values of the individual servo positions:
Activate“Steering”:Tapthe“Activate/Deactivate”button.Turnthecontrolwheelforthesteeringfunctiontotheleftor
right and hold the desired position. Tap the “Back” button to save the new values and return to the previous menu.
Deactivate“Steering”:Selectthe“Steering”function.Tapthe“Activate/Deactivate”buttontodeactivatethesetvalue.
Thevaluessetwiththetransmitterencoders(e.g.steeringwheel)forthefailsafefunctionaredisplayedinthedisplay
ofthefunction“Failsafe”whenthefunctionisactivated.Ifaprogrammedfailsafevalueisdeactivated,thesetvalueis
permanentlydeletedandneedstobere-setwhenthefailsafefunctionisactivated.
Activate“Throttle”:Tapthe“Activate/Deactivate”button.Pulltheaccelerator/brakeleverforwardsorbackwardsand
hold the desired position. Tap the “Back” button to save the new values and return to the previous menu.
Deactivate“Throttle”:Selectthe“Throttle”function.Tapthe“Activate/Deactivate”buttontodeactivatethesetvalue.
“Display sensors”:
This function shows you all the information regarding all connected sensors.
“Choose sensors”:
This function shows the information of up to four sensors on the main screen. Tap the parameter and select the
desiredsensor.Inadditiontothedisplayofthetransmitterandreceivervoltage,youcanselectthe“Signalstrength”
(valuesfrom1-10),“RSSI”(receivingeldstrengthindBm),“Noise”ofthereceived
“Speed and distance”:
This function enables you to programme a rotation counter or an odometer connected to the receiver.
Tapthe“Speedsensor”functiontoselectarotationcounter.“None”meansthatnonehasbeenselected.
Tap the “Set rotation length” function to set the circumference of the tyre that the rotation counter is connected to.
Tap“Resetodometer1”or“Resetodometer2”,toresetthevirtualodometerbackto“0”.
“I-BUS setup”:
Thisfunctionpermitscontrolofallservoswithabussysteminconnectionwiththemenuitem“i-Setuputility”.
 Thisfunctioncannotbeusedyetatthemoment.Ifavailable,thecorrespondinginformationornewoperating
instructions can be found in the download area of the product.
“Servos frequency”:
Servosaretriggeredinacertainrhythm(framerate)withcontrolsignals.Thestandardfrequencyis50Hz.Special,
usually digital servos, require a higher control rate. Selectthe matching frequency according to the notes ofthe
servomanufacturer.
 Achangeofthecontrolfrequencyaffectsallcontrolelementsconnectedtothereceiver(e.g.speedcontrol-
ler,servos,etc.).
 Ifcontrolelementsthatareonlydesignedforatriggerfrequencyof50Hzaretriggeredatahigherfrequen-
cy,theymaybedestroyed.