User manual

37
15.19 “Display servos” function
Thisfunctionshowsyoureal-timeinformationregardingtheposi-
tionofallfourservolevers.Forthis,movethecontrolelementsof
thetransmitter(e.g.thesteeringwheel).
Click the icon “Servo lever” next to the green “Return arrow” to
activate a “Servo tester”. All the connected servos for the set values
(endpoints,rotatingdirections,etc.)aremovedautomatically.The
display for this is according to the movement of the servos at the
display.
15.20 “Race timer” function
This function allows you to set the timer function in four different
modes. Tap “Mode” to switch between the four different modes. The
following modes are available for use:
“Up timer”:
The mode starts the timer and ends only when the “Stop” button
is tapped.
Tapthe“Start”buttonto starttiming.Then,tapthe“Stop”button
to stop timing. To reset the counter back to “0”, tap the “Reset”
button.
“Down timer”:
This mode allows you to count down from a individually set time.
Slide the regulator to the left or right to set a particular time. The set
timeintervalsareadjustedbyaminuteeach.Tapthe“Start”button
tostarttiming.Then,tapthe“Stop”buttontostoptiming.Toreset
thecounterbackto“0”,tapthe“Reset”button.
Figure 30
Figure 31