User manual

34
15.15 “Engine cut” function
Thisfunctionisusedtoignorethepositionoftheaccelerator/brake
leveroftheremotecontrolandsettheaccelerator/brakeservoto
apredenedposition.
A chosen switch (e.g. SW1 to SW3) must be assigned to the
“Engine cut” function. This is done in the “Keys Function”.
Push the switch programmed for “Engine cut”. Push the controller
totherightorlefttoadjustthevaluetoyourwishes.Bypushingthe
switchintendedfor“Enginecut”,youcannowactivate/deactivate
the function “Engine cut”.
Any switchable function can be assigned in any submenu
ofthe switches (e.g. SW1to SW3).You needto scroll
the display content for overview. The display shows the
corresponding icon with the function activated.
15.16 “Boat mode” function
This function permits moving the throttle lever along the entire ser-
vo path from the neutral position. A brake function therefore is not
intended for.
With the function activated, the throttle servo (or the electronic
speedcontroller)issettotheendstopwiththethrottleleverofthe
transmitterintheneutralposition(motoroff).Nowmovethethrottle
leverofthetransmittertowardsfullthrottle(theleverispulledto-
wardsthegrip),theservo(ortheelectronicspeedcontroller)will
move towards full throttle. If the throttle lever is pulled completely
towardsthegrip,theotherendstopisreached.
Figure 25
Figure 26