User manual

33
15.13 “Throttle middle position” function
Thisfunctionpermitschangingtheservoadjustmentpathstarting
in the neutral position of the throttle lever.
Theexampleshowningure23wouldmovethethrottleservo(or
theelectronicspeedcontroller)by60%oftheservocontrolpathif
the throttle lever at the transmitter is moved from the neutral posi-
tion towards full throttle. If you move the throttle lever at the trans-
mitterfromtheneutralpositiontowardsthebrake,thethrottlelever
wouldonlymoveby40%oftheservocontrolpath.
Slidetheregulatortotherightorlefttoadjustthevalue.Tapthe
“Back” button to save the new values and return to the previous
menu.
15.14 “Throttle idle up” function
Thisfunctionenablesyoutoadjusttheneutralpositionoftheac-
celerator/brakeservo.Thiscanbeparticularlyusefulwhenyouare
operatingapetrol-poweredmodel.
This enables you to raise the idle revolutions when the engine has
not yet warmed up.
Achosenswitch(e.g.SW1toSW3)mustbeassignedtothe“Idle
up” function. This is done in the “Keys Function”.
Push the switch programmed for “Idle up”. Push the controller to
therightorlefttoadjustthevaluetoyourwishes.Bypushingthe
switchintendedfor“Idleup”,youcannowactivate/deactivatethe
function “Idle up”.
Any switchable function can be assigned in any subme-
nuof the switches“Keys function” (e.g.SW1 to SW3).
You need to scroll the display content for overview. The
display shows the corresponding icon with the function
activated.
Figure 23
Figure 24