User manual

30
15.9 “Throttle exponential” function
Thisfunctionenablesyoutoinuencethesensitivityoftheaccele-
rator/brakeservo.Indoingso,thelinearpathbetweenthecontrol-
lerandtheservoismodiedtoanon-linear(exponential)path.A
more sensitive control about the neutral position is thus possible.
Themaximumcontrolpathisnotmodiedwhendoingthis.
“Exp.”:
The value that can be set for this function is -100 % to 100 %,
wherebythevalue0%correspondstolinearcontrol.Amodication
of the set value always affects both sides of the servo end point
equally.
 Negativevaluesincreasetheservodeectionaroundthe
centre position.
“Rate”:
Here,theangleofthecurveisset.Thevaluethatcanbesetforthe
angleofthecurvedis0%to100%.Thelowerthevalueset,the
lowertheservodeection.
Selectthe“Activate”button.Then,selecttheparametertobechan-
ged. Slide the regulator to the right or left to change the value to suit
yourrequirements.Selectthe“Activate”buttontosavethecurrent
value. Tap the “Back” button to return to the previous menu.
15.10 “Throttle curve” function
This function enables you to adapt the acceleration acceptance be-
haviouroftheaccelerator/brakeservoina5-pointcurve.
Each individual point can be adapted individually. Values from
-100%to100%maybeset.
Selectthe“Activate”button.Then,selecttheparametertobechan-
ged. Slide the regulator to the right or left to change the value to suit
yourrequirements.Selectthe“Activate”buttontosavethecurrent
value. Tap the “Back” button to return to the previous menu.
Figure 19
Figure 20