User manual

28
15.7 “Steering mix” function
The steering type “Standard“ is chosen in the basic setting; no
further settings are possible.
Select the steering mode “Crawler mode“ to be able to make the
followingsettingsasalsoshowningure17.
“Front side”:
Onlythesteeringservoforfrontwheelsteering,connectedtoCH1
atthereceiver,willbeactivated.
“Rear side”:
Onlythesteeringservoforrearwheelsteering,connectedtoCH3
atthereceiver,willbeactivated.
“Same Phase”:
Front and rear wheels are controlled in the same way.
“Rev. Phase”:
Front and rear wheels are controlled in the opposite way.
Selectthe parameter tobe changed inorder toset the required
steering type. Tap the “Back” button to save the new values and
return to the previous menu.
Use the function “Same phase” or “Rev.phase” to trigger two steering servos at once with the steering movement at
thetransmitter.Steeringservo1isconnectedtoCH1,steeringservo2toCH3.Inthiscase,thecontrolbuttonhasno
functionatthetransmitterforCH3.
Thecontrolcharacteristicsforbothsteeringservoscanbesetindividually(CH1andCH3)inthemenuitems“Reverse,
EndpointsandSubtrim”.Forthefunctions“SteeringexponentialandSteeringspeed”,thesettingsofCH1serveas
masterandcontroltheCH3(slave)automaticallyforthesetvalue1:1.
Figure 17